All Products

VTS Opal Holographic Permanent Adhesive Vinyl 12"

9 products

You can use VTS Permanent Adhesive Vinyl in all cutting machines, such as Cricut and Silhouette, with die cuts, craft punches, and, of course, scissors.

We have all the products you need to let your imagination run wild & let your creativity take over!

We are a small, family-owned business located in Florida. All of our products are Made in the USA.

All of our products are Made in the USA

All of our vinyl comes with an adhesive on one side with a paper backing that protects the adhesive until exposed. Can be easily cut and applied allowing you to turn any flat or glass surface into a work of art!

Opal films reflects different color based upon the light reflecting off them. Color may vary slightly in person from the photo provided above based on the angle that you are viewing the product.

Film Thickness: 2 mil.
Outdoor Durability: 5-8 years
Adhesive: Permanent
Interior/ Exterior: Interior and Exterior

Cut Settings: Generally this film can be cut on the same settings as other standard adhesive vinyl film. We do recommend small test cuts and to adjust pressure accordingly and as required.

Note: Life expectancy can vary depending on harshness of UV exposure.

Cut Limitations: Due to stiffness of the film, smaller intricate cuts may be difficult to weed and work with, as well as have a lower tolerance for lifting from the surface after applied. We do not recommend sharp corners or edges as these may perpetuate peeling from the surface, especially if handled.

Tunneling:
Due to the stiffness of the film, when unrolled "tunneling" may occur which is when the film lifts from the release liner and bubbles or "tunnels" form. This can be corrected by simply lifting the film gently from the release liner and gently using a squeegee or other flat edge to lay the film back town prior to cutting.

Showing 1 - 9 of 9 products